Precision Fit Starts With Precision Measurement
Cut from your measurements. Not from standard sizing.
PDF • 36-point protocol • Reviewed before cutting begins
This Is Not Sizing. This Is Engineering.
A drysuit is not apparel.
It is mission-critical equipment.
Fit determines:
- Mobility under load
- Seal integrity
- Thermal efficiency
- Long-duration reliability
Each suit is individually cut from your submitted measurement protocol.
THE MEASUREMENT PROTOCOL
The Dive Labs protocol requires 36 precision measurements, covering:
- Core body geometry
- Limb articulation and reach
- Seal-critical dimensions
- Boot and glove integration
Measurement takes approximately 15–20 minutes.
You will need:
- Flexible measuring tape
- Fitted base layer clothing
- Flat floor and wall reference
A partner is required.
Measurements taken alone will not be accepted.
OFFICIAL CUSTOM FABRICATION PROTOCOL
This document is required for custom fabrication.
All 36 measurements must be completed before submission.
EVERY SET IS MANUALLY VERIFIED
Every submission is reviewed by a Dive Labs technician.
Prior to fabrication:
- Measurements are reviewed
- Irregular values are flagged
- You may be contacted for confirmation
Fabrication does not begin without verification.